Ender 3 - Filament spool holder + integrated run-out sensor.
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Should fit every printer using standard 20x (Nx20) aluminum extrusion.. NB! STILL A PROTOTYPE!
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 178
- Makes
- 0
- Views
- 1,533
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- GNU General Public License v3.0
Instructions
Both can be installed separately with M3x8mm screws and 20x20 M3 t-nuts. Both stand and sensors can be printed mirrored when you don't like the orientation. Current orientation : meant for standard E3, leaning inward, connected to the extruder by additional bowden tube. ( left side, facing forwards for the bowden setup, right side, facing backwards for the Direct Drive ). In both cases : bowden tube reaches around the side extrusion in order to keep it from getting into Z lead screw's or X toolhead's way. Compatible with my other models.
Example print in photos
ABS, 0.2mm; 4x wall/top/bottom layers, 20% infill.
Additional hardware needed:
| FILAMENT ROLL HOLDER | ||
| Name | Amount | Comments |
| M8 bolt 100mm (DIN931) | 1 | |
| M8 Nyloc nut | 1 | |
| Bearing spacers (ID 8mm, OD 10-12mm) | 2 | Printable model available. |
| M3 8mm screw | 2 | |
| M3 20x20 T-nut | 2 | |
| 688RS bearings (8x15x5mm) | 2 | |
| FILAMENT SENSOR with Creality endstop module | ||
| Name | Amount | Comments |
| Creality endstop module | 1 | Use Z endstop if you use ABL |
| M3 8mm screw | 3 | |
| Pneumatic connector with m6 thread | 1 (2) | Can be used on both ends |
| FILAMENT SENSOR with off the self microswitch | ||
| Name | Amount | Comments |
| Microswitch (6x6x13mm body) | 1 | |
| M3 8mm screw | 3 | |
| M2 10mm selftapping screw | 2 | |
| Pneumatic connector with m6 thread | 1 (2) | Can be used on both ends |