180 Degree Elliptic U-siphon for 1/2" PVC
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I was not too happy with having so many parts just to make a u-siphon so I designed this. I think it works a bit…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 234
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was not too happy with having so many parts just to make a u-siphon so I designed this. I think it works a bit better than a standard u-siphon from pvc elbows, but I'm sure it depends on your input flows and exit pipes, like with most siphons.
The "theoretical" sizes were really tight from the filament I used, so I messed around and determined the 103 scale was right for my printer to fit 1/2 inch PVC.
I had fun designing this, so I plan on designing some more special elbows, etc. If you have a request let me know I'll take a look.
If you like this design and use it and enjoy it's use, please consider coming back and giving a tip! I am a creator, so I like to know my time designing for Thingiverse and makers is well spent and could use the dollars. Or check out my Etsy! HutchisonCurioStudio.etsy.com
Print Settings
Printer:
Snapmaker
Rafts:
Doesn't Matter
Supports:
No
Resolution:
.2
Infill:
70
Filament:
Geeetech PLA
White
Notes:
No supports required. I recommend thick walls and decent infill since this part will be used and you want it to hold up.
Category: Hobby