Picture Hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printed in PLA, with 33% infill this is a very sturdy picture hanger. Attach it to drywall with a common nail up to…
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 225
- Wydruki
- 1
- Wyświetlenia
- 1410
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Share Alike
Printed in PLA, with 33% infill this is a very sturdy picture hanger. Attach it to drywall with a common nail up to 2.5mm in diameter (13 ga.).
The fine detail in the center also makes a good test to show how acceleration, jerk, temperature, and cooling impact your prints. As a bonus, when you are done with your test you have a mess of picture hangers to use when needed.
Print Settings
Printer:
D-Bot CoreXY
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
33%
Notes:
You can get by with less infill, but I went with that because Cura gave it a stronger internal support at the lower joint without much time penalty.
Category: Decor