Picture Hanger
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printed in PLA, with 33% infill this is a very sturdy picture hanger. Attach it to drywall with a common nail up to…
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 225
- Makes
- 1
- Views
- 1,410
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Share Alike
Printed in PLA, with 33% infill this is a very sturdy picture hanger. Attach it to drywall with a common nail up to 2.5mm in diameter (13 ga.).
The fine detail in the center also makes a good test to show how acceleration, jerk, temperature, and cooling impact your prints. As a bonus, when you are done with your test you have a mess of picture hangers to use when needed.
Print Settings
Printer:
D-Bot CoreXY
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
33%
Notes:
You can get by with less infill, but I went with that because Cura gave it a stronger internal support at the lower joint without much time penalty.
Category: Decor