1 / 2
Hex bit holder for peg board (Lidl / Parkside) — zdjęcie 1
1 / 2

Hex bit holder for peg board (Lidl / Parkside)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Holder for 18 hex bits with attachment to pegboard. Fits at least Lidl / Parkside pegboards.

Ocena
0 / 5
Polubienia
51
Pobrania
208
Wydruki
0
Wyświetlenia
1558
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial

I seem to be always losing especially the small torx bits, so I decided to design a holder for peg board where I have 3 of each size that I normally use, TX10, TX15, TX20, TX25 and TX30. This way it's easy to see when I am running low on certain bits, I will just buy a 3-pack of them as they are a couple of euros each 3-pack.

This is designed for my lidl / Parkside peg board, but if your pegboard has a pattern of 25mm*38mm like this one does, it will fit other brands too.

Print 4 of the “nibs” and use 3*12mm screws to screw them onto the holder, it holds very sturdy to the peg board.

Tagi