Elongated Snap on MK3/MK3S Camera mount for the Logitech C920 Webcam
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A long, clip-on camera mount for wide format webcams.
- Ocena
- 4,6 / 5
- Polubienia
- 66
- Pobrania
- 538
- Wydruki
- 11
- Wyświetlenia
- 3592
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I enjoyed this mount but wanted the camera a little further from the print bed. I elongated the arm by 60mm and then also lengthened the mount point so it can accommodate a thumb screw such as this
After using this for a while I found that it was still not far enough for larger prints. Given that I use Octolapse, the Y axis doesn't need the full horizontal view of a 16:9 camera (like my C920). I decided to alter the mount a second time to give a portrait mount point for the camera. To allow this to print without supports I had to then move the camera cable clips to the opposite face. The downside is that it makes the wire more visible.
I don't see why this wouldn't work for any light weight webcam that mounts with a 1/4" screw. The clips were designed by jsund to accommodate a 3mm cable. I've only tested it with a Logitech C920.