Elongated Snap on MK3/MK3S Camera mount for the Logitech C920 Webcam
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A long, clip-on camera mount for wide format webcams.
- Rating
- 4.6 / 5
- Likes
- 66
- Downloads
- 538
- Makes
- 11
- Views
- 3,596
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution
I enjoyed this mount but wanted the camera a little further from the print bed. I elongated the arm by 60mm and then also lengthened the mount point so it can accommodate a thumb screw such as this
After using this for a while I found that it was still not far enough for larger prints. Given that I use Octolapse, the Y axis doesn't need the full horizontal view of a 16:9 camera (like my C920). I decided to alter the mount a second time to give a portrait mount point for the camera. To allow this to print without supports I had to then move the camera cable clips to the opposite face. The downside is that it makes the wire more visible.
I don't see why this wouldn't work for any light weight webcam that mounts with a 1/4" screw. The clips were designed by jsund to accommodate a 3mm cable. I've only tested it with a Logitech C920.