Catalex/YX5300 (Serial UART MP3 Module) Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are mounts for the Catalex MP3 player, a board for the serial-controlled YX5300 MP3 chip.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 422
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This Printable contains two simple mounts for the Catalex MP3 player, a board for the serial-controlled YX5300 MP3 chip.
The Catalex attaches to either of the mounts with two to four M2 x 5 mm screws (you might be able to use M2.5 x 5, but this hasn't been tested). The outer mounting tabs have holes for M3 screws.
The Vertical mount is meant to be used so the board is held standing on edge (I used it so the SD Card extends through a slot in the surface that the mount attaches to). However, it should be printed lying flat on the print bed. On the Vertical mount, the two M3 holes have a sacrificial layer on each end; use a 3mm bit or a screw to open these holes before mounting.