1 / 1
Anycubic Kobra Go SKR Pico mount — zdjęcie 1

Anycubic Kobra Go SKR Pico mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

SKR Pico & Rpi Zero mount for the Anycubic Kobra Go

Ocena
5 / 5
Polubienia
13
Pobrania
114
Wydruki
1
Wyświetlenia
1238
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Mount for the Anycubic Kobra Go to use a SKR Pico and RPi Zero.

Included my Klipper config (running sensorless on x and y). 

You'll need to extend your bed thermistor wires slightly (just a couple inches) and repin your z endstop-probe to match the new board. You'll also need to remove the fan guard and rotate the fan 180.

The Pi can't sit above the Pico while still in the original case which is why it mounts to the side of the pico.

See the bottom of start.cfg for slicer start gcode.

Pic in klipper zip for bed offsets. I run 228 in X because 230 may run over while extruding. 230 in Y seems to be fine.

Update: V2 moved mounting point for skr so you may not have to extend any wires or rotate the fan. Untested.