Anycubic Kobra Go SKR Pico mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
SKR Pico & Rpi Zero mount for the Anycubic Kobra Go
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 114
- Makes
- 1
- Views
- 1,238
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Mount for the Anycubic Kobra Go to use a SKR Pico and RPi Zero.
Included my Klipper config (running sensorless on x and y).
You'll need to extend your bed thermistor wires slightly (just a couple inches) and repin your z endstop-probe to match the new board. You'll also need to remove the fan guard and rotate the fan 180.
The Pi can't sit above the Pico while still in the original case which is why it mounts to the side of the pico.
See the bottom of start.cfg for slicer start gcode.
Pic in klipper zip for bed offsets. I run 228 in X because 230 may run over while extruding. 230 in Y seems to be fine.
Update: V2 moved mounting point for skr so you may not have to extend any wires or rotate the fan. Untested.