Sony Spacer d70/50 h70
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer to bring up my BluRay-Player from the Amplifier and the Amplifier from the bottom.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 95
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Spacer to bring up my BluRay-Player from the Amplifier and the Amplifier from the bottom.
Print Settings
Printer:
Anet A8
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.12
Infill:
7
Notes:
Place the spacer up side down. Best results for me because of the Support.
Attention: Check the printing process in your slicer bevor you print! Had some issues in S3D. It sliced the tube into three vertical sections. Don't know why. After rotating up side down it was ok.
How I Designed This
Designed in Fusion but...
Doesn't make a diffrence how to design. Fusion or TinkerCAD. You have to design at first a tube. Second one letter. Place the letter on the surface of the tube and extrude negative.
Rotate the tube and design the next letter. Unfortunately you have to do this letter by letter.
Category: Organization
