Combined cooling shroud for Monoprice Select Mini v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Contains mounts for both 40mm hot-end cooling and 5015 part cooling fans. Also contains a model for just the 40mm fan
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
I was getting tired of my E3D Monoprice Select Mini's old cooling duct falling off, so I designed my own to secure directly to the hot end block. Yes, it should be made from ABS or ASA because it's directly in contact with the heater block, but I used PETG because I didn't have either, and anyways the cooling on this thing is just stupid.
The fan mount and fan grille are designed around M3 hex-head screws and nuts, and the fan, grille, and slide assembles, then slide down onto the shroud. It is designed to be very tight to avoid any rattling.
Printing Suggestions
I printed these all without supports, and they came out with only a bit of fuzz.
Disclaimer
I saw the design of a blower like this somewhere on Thingiverse, and now I can't find it again, so somewhere out there is a very, very similar duct, except it uses the clippy system the original hotend cooler used, and whoever designed it knew a lot more about making ducts more… ductlike.