Combined cooling shroud for Monoprice Select Mini v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Contains mounts for both 40mm hot-end cooling and 5015 part cooling fans. Also contains a model for just the 40mm fan
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 26
- Makes
- 0
- Views
- 320
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Public Domain
I was getting tired of my E3D Monoprice Select Mini's old cooling duct falling off, so I designed my own to secure directly to the hot end block. Yes, it should be made from ABS or ASA because it's directly in contact with the heater block, but I used PETG because I didn't have either, and anyways the cooling on this thing is just stupid.
The fan mount and fan grille are designed around M3 hex-head screws and nuts, and the fan, grille, and slide assembles, then slide down onto the shroud. It is designed to be very tight to avoid any rattling.
Printing Suggestions
I printed these all without supports, and they came out with only a bit of fuzz.
Disclaimer
I saw the design of a blower like this somewhere on Thingiverse, and now I can't find it again, so somewhere out there is a very, very similar duct, except it uses the clippy system the original hotend cooler used, and whoever designed it knew a lot more about making ducts more… ductlike.