1 / 1
3D Print GT2 80t 5mm Bore - 6mm Belt Pulley (Remix) — zdjęcie 1

3D Print GT2 80t 5mm Bore - 6mm Belt Pulley (Remix)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fully 3D printed 80 tooth GT2 pulley with 5mm bore for 6mm belt, glue assembly, no screw

Ocena
5 / 5
Polubienia
50
Pobrania
815
Wydruki
1
Wyświetlenia
4365
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a remix of thing:5158444 that I modify to suit my need

the original design is working ok, but I want to simplified the 3D model.. I'm omitting the screw-assembly and opt for glue-assembly only, adjusted the locking-tab and notch to fit more easily

you can use slow-setting Cyanoacrylate or Epoxy for better control when spreading the glue, instant Cyanoacrylate (Crazy Glue) would be too difficult to control it's flow and risking to ruining the teeth

carefully spread the glue on the inner face just before the teeth and bore for about 5mm, put decent amount into the notch too, clamp both parts with sufficient and equal pressure around it's circumference.. prior that, give a good estimation so that the glue won't bleed onto the teeth, also make sure both part matching nicely and lay flat to each other when clamped

the mount screw hole is 3mm, you can use M4 tapping screw for mounting.. I use M4x15mm tapping screw which I grind the point flat

I use this as temporarily solution for my project till I get good quality aluminum GT2 80t pulley, so use at your own risk


Print on ABS, 0.16 height, 0.5 width, 150°C, 2.0 wall width, 2.0 top-bottom, 40%cubic  infill, with ironing on, need no support but some brim might help from warping

Tagi