3D Print GT2 80t 5mm Bore - 6mm Belt Pulley (Remix)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fully 3D printed 80 tooth GT2 pulley with 5mm bore for 6mm belt, glue assembly, no screw
- Rating
- 5 / 5
- Likes
- 50
- Downloads
- 815
- Makes
- 1
- Views
- 4,365
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is a remix of thing:5158444 that I modify to suit my need
the original design is working ok, but I want to simplified the 3D model.. I'm omitting the screw-assembly and opt for glue-assembly only, adjusted the locking-tab and notch to fit more easily
you can use slow-setting Cyanoacrylate or Epoxy for better control when spreading the glue, instant Cyanoacrylate (Crazy Glue) would be too difficult to control it's flow and risking to ruining the teeth
carefully spread the glue on the inner face just before the teeth and bore for about 5mm, put decent amount into the notch too, clamp both parts with sufficient and equal pressure around it's circumference.. prior that, give a good estimation so that the glue won't bleed onto the teeth, also make sure both part matching nicely and lay flat to each other when clamped
the mount screw hole is 3mm, you can use M4 tapping screw for mounting.. I use M4x15mm tapping screw which I grind the point flat
I use this as temporarily solution for my project till I get good quality aluminum GT2 80t pulley, so use at your own risk
Print on ABS, 0.16 height, 0.5 width, 150°C, 2.0 wall width, 2.0 top-bottom, 40%cubic infill, with ironing on, need no support but some brim might help from warping