OP1 Field Clip On Desk Stands
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These clip on legs for your OP1-Field will prop up your instrument to the perfect angle when working on a table.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 187
- Wydruki
- 2
- Wyświetlenia
- 1051
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
Each side is the same so you can just copy the model in the slicer and print two at once. To use the stands, start by hooking the bottom side to the bottom edge of the OP1-Field and then you should be able to just kinda snap the top hook of the stand over the top edge of the instrument. Make sure you line up the round indents on the stand with the rubber feet on the back of the instrument. The stands are designed to clip on and sit snugly on top of the rubber feet so that they don't slide off the sides of the instrument.
Printed with Galaxy Silver PLA, (the stuff that came with my prusa mk3s)
.4 Nozzle
.2 layer Speed preset in prusaslicer
check out my power switch cover too :)