Twist Connector for DN50 Hose
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I am using DN50 hoses/pipes in my workshop to get dust from one point to another. After going through a number of…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 303
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I am using DN50 hoses/pipes in my workshop to get dust from one point to another. After going through a number of systems, I designed this bayonet-style connector. The goal was to make something that I could easily connect and disconnect, preferrably with one hand if one of the two parts was held in place somehow. Thus far it works!
Important: To save on filament, I designed these for a piece of DN50 plastic pipe to be glued into them, either as a connector to that pipe or as a piece to attach a hose to. I had enough pupe laying around for that, but it also makes that end of the connector a lot more sturdy compared to a 3d printed pipe piece.
Print the outside part with supports.