Adapter for Roller Shutter Motor EVEROXX ERM 20/15 Ø45mm für 60mm DriveShaft
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed to replace my bad rolling shutter motor. Didn't want to replace by original part as this was too expensive for…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 383
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
Needed to replace my bad rolling shutter motor. Didn't want to replace by original part as this was too expensive for me and not durable. So I bought something rigid and tough and inexpensive with manual adjustable limit switches. Electronic of my previous High-Tech shutters failed (2 out of 8!).
During repair works I figured out that the org. adapter was too short, so I designed this and am happy with it.
The driveshaft is an octoagonal shaft (8-Kant-Welle Ø60mm). For axial fixation I drilles two Ø4mm holes into the shaft (180° opposite sides). Measured the necessary distance when all bearing points are met. Then drilles a Ø4mm hole through the PETG (Be carefull and do not damage the motor by drilling too deep!), inserted a heat inset and fixed the shaft on two places with an M3 countersink screwhat screw. Works fine!
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3 MMU 2
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
0.20mm
Infill:
25%, 4-5 perimeters@4mm nozzle
Filament: Sunlu PETG Black
Notes:
hole for heat inset drilled later. Enough skin in the game! Haha.
Category: Household