1 / 6
Spare Gasket (Sealing, Dichtung) for Thomas Central Vacuum — zdjęcie 1
1 / 6

Spare Gasket (Sealing, Dichtung) for Thomas Central Vacuum

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

After my sealings needed to be replaced I bought original sealings, which consisted of a simple foampad of about 2-3mm…

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
246
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

After my sealings needed to be replaced I bought original sealings, which consisted of a simple foampad of about 2-3mm thickness. Now this is very simple and cheap material for 3EUR per piece.

I had cleaned the surface of the ABS lid in order to receive a good and durable tack, but already after few times in use tese pads released from the ABS lid, so my vacuum system with 5 attaching points got untight more and more, the vacuum effectiveness behaved the same, got really worse. All substitutes I treid out were not the solution.

Now I designed a pad and printed it with my Elegoo Mars 2 Pro. Material Monocure Flex (100%). After few adaptions I think I got the right dimensions. Thickness I needed to play with.Now set to 2.4mm and I glued the part in with some far-east mobile repair glue with the expectation it stays innplay for longer than the previous mentioned org. parts. After glueing I pressed the sandwich moderately with two fitting pieces of wood, in order to get a nice tack. My today's impression is that it works. At least the sealings in place work.

I do not hear whistling noises like before, by far NOT! Which is good. Hope it will still be good in couple years?

Explore my other Printables: https://www.printables.com/de/@Tritschi 

Print Settings

Printer:

Elegoo Mars 2 Pro

Rafts:

No

Supports:

No

Resolution:

0.05mm

Infill:

100%

Filament:

Monocure Resin Flex Resin

translucent


Notes:

The Elegoo Mars 2 Pro has a 4K monochrome display, Therefore exposure times are less than color displays.
I used 4 bottom layers per each 15 seconds.

The rest I exposured with 5.5 seconds.

I use a WhamBam flexible build plate. After cleaning in IPA I let it dry by blowing contant air for about 15 minutes. While the part was still on the plate I put it into a sealed plastic zipper bag and let it stay for about 20 minutes in the freezer. Then took it out and bent the WhamBam a bit, part became immediately loose, then I dried again for couple minutes unless I cured it in my Elegoo Mercury Wash & Cure for 3 minutes. End result of part is excellent!

Category: Household

Tagi