1 / 6
Spare Gasket (Sealing, Dichtung) for Thomas Central Vacuum — image 1
1 / 6

Spare Gasket (Sealing, Dichtung) for Thomas Central Vacuum

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

After my sealings needed to be replaced I bought original sealings, which consisted of a simple foampad of about 2-3mm…

Rating
0 / 5
Likes
1
Downloads
10
Makes
0
Views
246
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

After my sealings needed to be replaced I bought original sealings, which consisted of a simple foampad of about 2-3mm thickness. Now this is very simple and cheap material for 3EUR per piece.

I had cleaned the surface of the ABS lid in order to receive a good and durable tack, but already after few times in use tese pads released from the ABS lid, so my vacuum system with 5 attaching points got untight more and more, the vacuum effectiveness behaved the same, got really worse. All substitutes I treid out were not the solution.

Now I designed a pad and printed it with my Elegoo Mars 2 Pro. Material Monocure Flex (100%). After few adaptions I think I got the right dimensions. Thickness I needed to play with.Now set to 2.4mm and I glued the part in with some far-east mobile repair glue with the expectation it stays innplay for longer than the previous mentioned org. parts. After glueing I pressed the sandwich moderately with two fitting pieces of wood, in order to get a nice tack. My today's impression is that it works. At least the sealings in place work.

I do not hear whistling noises like before, by far NOT! Which is good. Hope it will still be good in couple years?

Explore my other Printables: https://www.printables.com/de/@Tritschi 

Print Settings

Printer:

Elegoo Mars 2 Pro

Rafts:

No

Supports:

No

Resolution:

0.05mm

Infill:

100%

Filament:

Monocure Resin Flex Resin

translucent


Notes:

The Elegoo Mars 2 Pro has a 4K monochrome display, Therefore exposure times are less than color displays.
I used 4 bottom layers per each 15 seconds.

The rest I exposured with 5.5 seconds.

I use a WhamBam flexible build plate. After cleaning in IPA I let it dry by blowing contant air for about 15 minutes. While the part was still on the plate I put it into a sealed plastic zipper bag and let it stay for about 20 minutes in the freezer. Then took it out and bent the WhamBam a bit, part became immediately loose, then I dried again for couple minutes unless I cured it in my Elegoo Mercury Wash & Cure for 3 minutes. End result of part is excellent!

Category: Household

Tags