Parking brake for cars
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parking brake I've designed and mounted in my garage to stop our cars at the right spot
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 327
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Hi,
I wanted our cars to stop at the right position in the garage every time. I know a lot of you have signs or tennis balls dangling from above, but I wanted something mounted to the floor.
Designed this in two parts to have it wider than I could print in a single piece. There are holes for a bolt and washer that goes into my garage floor. I've got 1 for each car as I only need to catch 1 tire. Theres a plug for the holes to stop it from filling with dirt.
I printed these in ASA with adaptive cubic infill. I did get some warping, but it's not a problem for it's use case.