CalDigit TS4/TS3 under desk holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My goal was to design a CalDigit TS4/3 under desk mount that would fit my needs: Multiple mounting options, under…
- Ocena
- 4,5 / 5
- Polubienia
- 33
- Pobrania
- 298
- Wydruki
- 2
- Wyświetlenia
- 2241
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
My goal was to design a CalDigit TS4/3 under desk mount that would fit my needs:
- Multiple mounting options, under desk, desk top, wall mount etc.
- Tabs that to retain the dock but allow for easy removal should you need to remove the dock temporarily.
- Screws or a large surface for VHB tape/dual lock.
- Keep decent airflow all the way around to prevent overheating.
- Easily printable on smaller beds, so a two part design.
- No supports or advanced printing modes needed.
- Looks nice!
When mounting the two halves you should be mindful of the fitment around the dock which is quite critical, for this reason I chose to use 3M VHB tape rather than screwing to my desk. A close fit will ensure that the tabs can adequately hold the dock in place but still be able to flex out of the way when enough force is applied.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Resolution:
0.28
Infill:
20
Filament:
eSUN PLA+
Grey
Notes:
3 perimeter walls recommended for rigidity, 20% infill works fine, but you could consider 100% (solid) for a really solid mount.
Print in vertical orientation with tabs at the top.No supports should be necessary as hexagon overhangs should print with adequate part cooling.
Category: Computer