1 / 4
Monitor stand with Honeycomb pattern and two shelves for storage
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this Monitor stand based on other designs I found here on printables. The honeycomb is created in the slicer.
- Ocena
- 5 / 5
- Polubienia
- 58
- Pobrania
- 234
- Wydruki
- 1
- Wyświetlenia
- 1855
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (0)Kolekcje (78)Powiązane
This monitor stand requires no screws or glue if your plywood (or other material for the shelves) fits well. Dimensions are 200mm wide x 140mm high x 20mm extrusion depth.
In the slicer, you can customise to your liking, but these were my settings:
- PLA
- 6 perimeters for strength
- Infill 7% Honeycomb (fill angle 0°)
- 0 layers top and 0 layers bottom (to expose the infill pattern)
- to add with plate adhesion, you may want to add a brim
I found if you play with the infill settings, you can get some other nice patterns out of it.