Ender 5 X Stepper Cover with Wire Anchors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple replacement for the Ender 5's X stepper cover using stock screws. It adds two spots for zip ties to…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a simple replacement for the Ender 5's X stepper cover using stock screws. It adds two spots for zip ties to aid cable management. This also prevents the wire harness from snagging on the outside of the X axis during long prints (as it is prone to sagging from heating).
This is a particularly handy mod for printers on direct drive where the Bowden tube no longer provides support to the wire harness. I use wire wrap with a length of PTFE tube running with the wires for added rigidity.
Installation
- Remove the X stepper cover sticker.
- Unscrew three of the screws.
- Use one hand to hold the X stepper in place while you remove the fourth screw.
- Position the new cover and insert one screw just enough to grab the stepper.
- Partly thread in a second screw on the opposite side of the stepper.
- Let go of the stepper and finish inserting and tightening the four screws.
Category: 3D Printer Parts