Clip-in Thermometer and Hygrometer stand and double-sided tape mount for dryboxes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Can be used with any standard-size 28x47mm clip-in hygrometer or thermometer.
- Ocena
- 5 / 5
- Polubienia
- 38
- Pobrania
- 373
- Wydruki
- 5
- Wyświetlenia
- 1374
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Fits pretty much any standard-sized 28x47mm clip-in hygrometer or thermometer.
There are two versions. One as a free-standing 45° angled stand and one that is made to be sticked to a clear container (filament storage/larger drybox) using some double-sided tape. The “wings" are 20mm wide to have enough surface to stick.
The hygrometer fits a bit loose, wiggling around a bit. This is so it can be removed if needed by squeezing the taps. I figured it was too hard/impossible to remove if the fit was too snug. On both holders the backside of the hygrometer is exposed so you can still swap batteries and the sensors are not blocked.
I advise to use the pre-rotated and supported files since this print needs support in the frame.