HeatBed Soldered Cable Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Keeps Cable from dragging especially when using current YZ Case!
You must cut swaged ends of cable and solder to the contacts. Strip insulation at end and loop onto top from underneath the board.
Second screw requires drilling a hole in the heater bed support pcb, screw the top cover from below at first screw, mark location for second screw and drill, 1/8 inch drill bit works.
Inserts for hex bolts and M3 screws should pop out.
It helps to add part of a large cable tie as part of the bundle and taping the group a couple times before you cover it up with fabric cover.
Print instructions
Prints with inserts which need to be popped out...