outdoor RGB LED clip for awning/eavestrough/soffit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Super easy print - 100% infill. one end slides under border of awning - self tapping screw holds rest in place
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 753
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
I bought some white PCB water resistant RGB Strips and wanted to stealthily mount them permanently to my house - to stop with the yearly chore of putting up/down the christmas lights.
I didn't trust the double sided tape, so I designed these clips to make sure they're up there good.
Print as pictured, solid infill, 0.4mm nozzle as I made most of it 0.8mm thick.
The two strands in the screw hole are to retain a screw so it doesn't fall out while you're working over your head. One end slides in under the edge of the awning, over the RGB Strip, and then a self tapping screw (last picture) driven in by a socket makes it easy and permanently installed. I've had these installed for 3 years now, no failed LED's and the clips are holding up well despite being in indirect light and just cheap PLA. I cracked a few during installation from overtightening with my drill, but they still held together and did their job.