1 / 3
outdoor RGB LED clip for awning/eavestrough/soffit — image 1
1 / 3

outdoor RGB LED clip for awning/eavestrough/soffit

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Super easy print - 100% infill. one end slides under border of awning - self tapping screw holds rest in place

Rating
0 / 5
Likes
8
Downloads
94
Makes
0
Views
758
Reviews
0

Updated at source:

Model information

Category
Home Decor
License
Creative Commons — Attribution — Noncommercial

I bought some white PCB water resistant RGB Strips and wanted to stealthily mount them permanently to my house - to stop with the yearly chore of putting up/down the christmas lights. 

I didn't trust the double sided tape, so I designed these clips to make sure they're up there good. 

Print as pictured, solid infill, 0.4mm nozzle as I made most of it 0.8mm thick. 
The two strands in the screw hole are to retain a screw so it doesn't fall out while you're working over your head. One end slides in under the edge of the awning, over the RGB Strip, and then a self tapping screw (last picture) driven in by a socket makes it easy and permanently installed. I've had these installed for 3 years now, no failed LED's and the clips are holding up well despite being in indirect light and just cheap PLA. I cracked a few during installation from overtightening with my drill, but they still held together and did their job. 

 

Tags