Dynam ME262 Cockpit Frame with FPV Pan and Tilt mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a cockpit frame I developed for Dynam's ME262 twin 70mm edf jet. I wanted an FPV experience to simulate…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 826
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This is a cockpit frame I developed for Dynam's ME262 twin 70mm edf jet. I wanted an FPV experience to simulate sitting in the cockpit. But the canopy that comes with the kit is just painted clear plastic and trying to look through that would create terrible picture quality for FPV. So this frame is an open air canopy, but with all the structure the pilot would have to look around in real life, creating a more true to life experience for the FPV'er
I also designed a mount that allows a standard wood pan and tilt assembly (from readymaderc) to be used. Simply hog out the foam as required from the Dynam center cockpit piece and glue the mount into place. The pan and tilt assembly screws into the printed mount.
Print Settings
Printer Brand:
MakerBot
Printer:
MakerBot Replicator 2
Rafts:
Yes
Supports:
Yes
Resolution:
.2mm or better
Infill:
50%
Filament: Esun ABS Gray
Notes:
The canopy frame is an exceptionally difficult print. I suggest supporting the entire perimeter (on a raft) along with the frame of the front window. And at least the top 1/3rd of all the side uprights and overhead which requires full support as well. Good luck!
Category: R/C Vehicles