Mount for Nerdcam 3D
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for protecting the bare pcb and lenses of the Nerdcam 3d. The mount provides for four 2mm screws at…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a mount for protecting the bare pcb and lenses of the Nerdcam 3d. The mount provides for four 2mm screws at the stock mounting locations. The screws will self thread into the plastic, with a little pressure (even machine screws). It also has enough room behind the pcb when mounted to connect any wires or add any additional pins you may need. Also there is a generous pass through hole in the bottom center for wiring. The coverbase, covers the pcb and the lens housings. And the covertop provides protection to the lenses and adds a little bling. The covertop and coverbase are meant to be glued together, or you can just leave the covertop off altogether to save a little weight.
*Update 3-1-2015* Added Nerdcamwholecover.stl for those brave enough to try and print it with supports, or if you have a hips capable printer.
Instructions
The mount was made with two shells and 25% infill, as was the coverbase. The covertop was 2 shells and 15% infill. All models were scaled up 1.01 (in x and y only) to account for ABS shrinking on my printer. Adjust as necessary for your printer and material choice.
Category: R/C Vehicles