1 / 2
FMS 1700 Piper PA-18 Super Cub Wing-mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The FMS 1700mm Piper PA-18 Super Cub wing-mount posts are prone to breakage - well at least my dad's broke.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 91
- Wydruki
- 0
- Wyświetlenia
- 1042
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- BSD License
The FMS 1700mm Piper PA-18 Super Cub wing-mount posts are prone to breakage - well at least my dad's broke. Unfortunately, the mounts are glued to the foam fuselage and a new fuselage costs $70USD+shipping. Here is a replacement part for the rear-ward post/mount that is thicker and hopefully stronger than the original.
Notes:
- You will need to remove the old post/plastic mounting parts from the foam fuselage prior to install using mineral spirits or acetone to dissolve the glue
- You may need to shave some foam off the fuselage to ensure proper fitment of this part since it is slightly thicker than the OEM part
- Minor sanding/filing of the post corners may be required for a good fit inside the wing cavity
- Rather than embed a brass nutsert like the OEM design, my approach includes a nut-trap so you can drop in an off-the-shelf M3 hex nut and re-use the original M3x16mm bolt. You can glue it in place with a few drops of CA (superglue) or hot melt glue after test fitment of the wing. You'll need to glue the new part on with FoamTac or similar adhesive spray.
- The model is for the left-side (port) - so mirror about the [Z-X plane] it to get the right-side (starboard)
Reference Links:
Print Settings
- Brim: Yes
- Supports: Yes
- Resolution: 0.2
- Infill: 20%
- material: PETG or BS
- Depending on your slicer software and printer accuracy, you may need to clean stray filament out of the nut trap prior to fitting the nut.