Full Sized Wizard Wand or Staff
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Expanding on my Bo Staff (http://www.thingiverse.com/thing:221634), here's a set of parts for Wizard staff or wand. I…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 50
- Wydruki
- 0
- Wyświetlenia
- 990
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial
Expanding on my Bo Staff (http://www.thingiverse.com/thing:221634), here's a set of parts for Wizard staff or wand.
I added a 3-fingered claw and an orb to the top. Fun for all ages.
If anyone likes this, but wants a different design to put on the top, let me know and I'll see what I can do. Or, you could design your own using Thing# 218949 as the start point. The posts for the staff will fit in a cap using the default parameters in the posted oscad file.
Instructions
Sliced at Medium quality in Makerware (0.2 mm layer height, 10% infill). Printed on a Replicator 2 in PLA. All parts are printable without supports. You get a bit of drooping at the connector edges, but it can be trimmed easily with a razor blade or by hand (if you have small hands).
2 linkers and the 40mm radius orb make a good sized wand.
I'm 5'10" and it took 11 connectors, 10 linkers, and 1 end caps and one orb to get a staff my height.
Once all the parts were printed, I snapped them together by hand. It's a tight fit, so you need to wiggle them together a little bit at a time. If you apply too much force, the posts can snap. To reduce the damage from a break, I put a linker on each of the posts first, then started linking the posts together.
Category: Props