Full Sized Wizard Wand or Staff
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Expanding on my Bo Staff (http://www.thingiverse.com/thing:221634), here's a set of parts for Wizard staff or wand. I…
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 50
- Makes
- 0
- Views
- 990
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial
Expanding on my Bo Staff (http://www.thingiverse.com/thing:221634), here's a set of parts for Wizard staff or wand.
I added a 3-fingered claw and an orb to the top. Fun for all ages.
If anyone likes this, but wants a different design to put on the top, let me know and I'll see what I can do. Or, you could design your own using Thing# 218949 as the start point. The posts for the staff will fit in a cap using the default parameters in the posted oscad file.
Instructions
Sliced at Medium quality in Makerware (0.2 mm layer height, 10% infill). Printed on a Replicator 2 in PLA. All parts are printable without supports. You get a bit of drooping at the connector edges, but it can be trimmed easily with a razor blade or by hand (if you have small hands).
2 linkers and the 40mm radius orb make a good sized wand.
I'm 5'10" and it took 11 connectors, 10 linkers, and 1 end caps and one orb to get a staff my height.
Once all the parts were printed, I snapped them together by hand. It's a tight fit, so you need to wiggle them together a little bit at a time. If you apply too much force, the posts can snap. To reduce the damage from a break, I put a linker on each of the posts first, then started linking the posts together.
Category: Props