Spool holder for The Virtual Foundry composite filaments
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design is a spool holder for the composite filaments from "The Virtual Foundry". Those filaments are brittle and…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 149
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design is a spool holder for the composite filaments from "The Virtual Foundry".
Those filaments are brittle and need to be positioned in a specific position on top of your printer. This spool holder is designed to be attached to a 20*20 aluminum profile and provide minimum resistance by using ball bearings to hold the spool tightly.
To make this you will need 9 Ball Bearings 624 (4X13X5mm) and 15 M3 screws (10 to 20mm). I can provide a model using M4 screws if asked.
You will also need 4 M5X10 screws and T nuts to attach to the aluminum profile.
The virtual foundry spools have a center diameter of 66mm and this design will not work well with smaller spools (most of them).
Category: 3D Printing