Anker A8346 Dock - W I D E Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed SlavaSlenin's remix of Danol's original Anker SteamDeck Dock to fit the SteamDeck with a Spigen case on!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 236
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
Remixception of a SlavaSlenin's remix of the original Anker SteamDeck Dock by Danol. Modified to fit my SteamDeck inside a Spigen case, but it might work with some other thinner cases.
Print process was a bit of trial and error, despite having a caliper and a rough idea of how much I wanted to move stuff around. Used Tinkercad to splice and adjust the model.
Idea is to print SlavaSlenin's base and then use the suggested infill settings provided in Danol's original:
Tolerances were made for printing at 0.3mm layer height.
IMPORTANT! Print the top piece as mesh, if the hubs are fully enclosed they will 100% overheat! (top layers: 0, bottom layers: 0, wall line count: 8, infill pattern: lines, infill density: 20% or less)
I printed at 0.2mm height, but followed the settings above. Used an infill of about 15% from what I recall in sparkly-grey PLA with pretty good results!