Anker A8346 Dock - W I D E Remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remixed SlavaSlenin's remix of Danol's original Anker SteamDeck Dock to fit the SteamDeck with a Spigen case on!
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 236
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Video Games
- License
- Creative Commons — Attribution — Noncommercial
Remixception of a SlavaSlenin's remix of the original Anker SteamDeck Dock by Danol. Modified to fit my SteamDeck inside a Spigen case, but it might work with some other thinner cases.
Print process was a bit of trial and error, despite having a caliper and a rough idea of how much I wanted to move stuff around. Used Tinkercad to splice and adjust the model.
Idea is to print SlavaSlenin's base and then use the suggested infill settings provided in Danol's original:
Tolerances were made for printing at 0.3mm layer height.
IMPORTANT! Print the top piece as mesh, if the hubs are fully enclosed they will 100% overheat! (top layers: 0, bottom layers: 0, wall line count: 8, infill pattern: lines, infill density: 20% or less)
I printed at 0.2mm height, but followed the settings above. Used an infill of about 15% from what I recall in sparkly-grey PLA with pretty good results!