Waterlevel sensor mount with cableguide

I need to fill up a water container once in a while and want to stop the water flow, when the water has reached a certain level.

For this I created this mount. Just screw in a standard water level sensor, guide the cables through the cable channel and connect it to your water level controller. Optionally, the cable can be zip-tied to the mount (see picture).

The mount has brackets to hang the mount into your water container. I added two brackets to choose between two different water levels depending on how much water I need.

Print instructions:
 

• ideally print with PETG, because the bracket might get in contact with water
• printing with 0,3mm layer height is sufficient
• Add support to the gap, where the sensor will be attached (see picture)