1 / 3
Waterlevel sensor mount with cableguide
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
I need to fill up a water container once in a while and want to stop the water flow, when the water has reached a certain level.
For this I created this mount. Just screw in a standard water level sensor, guide the cables through the cable channel and connect it to your water level controller. Optionally, the cable can be zip-tied to the mount (see picture).
The mount has brackets to hang the mount into your water container. I added two brackets to choose between two different water levels depending on how much water I need.
Print instructions:
- ideally print with PETG, because the bracket might get in contact with water
- printing with 0,3mm layer height is sufficient
- Add support to the gap, where the sensor will be attached (see picture)