1 / 4
Retainer / Invisalign Container
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A closable container to store and protect orthodontic retainers / invisaligns
- Ocena
- 5 / 5
- Polubienia
- 68
- Pobrania
- 467
- Wydruki
- 11
- Wyświetlenia
- 1709
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 11) (Komentarze: 16)Remiksy (0)Kolekcje (51)Powiązane
I could not find a suitable retainer box that did not also require magnets or screws to assemble, so I designed a box that works without any additional materials.
Can be clipped shut, and opened by applying a slight pressure to the front of the box and opening the lid. Has drainage holes / vents on the bottom.
To print:
- For both:
- 20% infill
- PLA
- 0.4mm nozzle
- The box: flat side down, at 0.2mm layer height
- The lid: flat side down, at 0.12mm layer height, with “supports on base plate only” just to keep hinge joint as spherical as possible
- It should be possible to print at 0.2mm, however the sloped inner walls might be a bit more noticable
- It should also be possible to print without supports, but it only needs about 0.03g of support, so I used them to be safe
To assemble:
- connect the clip on the lid to one side of the box hinge
- carefully pull the other side of the lid hinge around and click it into place - it should have enough clearance to pull it on with just a bit of force
Specs:
- 80mm wide
- 67mm deep
- 39mm tall (lowest height 35mm, as it's slightly higher on the front)
Printed in Prusament Galaxy Black PLA.