1 / 2
Best LED Diffuser - Pixelated neopixel progress & status bar
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Instead of just taping an LED strip to an extrusion, this creates a unique look
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 607
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (26)Powiązane
This is a 4 piece model designed to snap together and be attached to a 2020 extrusion, it is 300mm long, but can be scaled up or down.
It uses a 144 LED/Meter argb strip to have high pixel density, and plugs right into your mainboards LED port. I used this and this for adding effects with klipper. I believe marlin has support for neopixels too.
You will need:
- 144 LED/M LED strip like this
- Some sort of ~20awg or similar wire
- Some dupont 2.54 connectors for the mainboard
Print Info
- Print the case in black
- The ‘Diffuser cover’ should be a transparent black/gray, if you use white the pixels will look blurry
- The LED segment part should be printed in a silk/gloss light color PLA. IF you use white each LED will light up 2-3 segments from light bleeding through, black won't allow the light to fully fill up each segment. Some sort of shiny silk works best, I used silk silver
- The thin sheet should be printed in white, and should only be 3 layers (0.6mm) thick
- Everything snaps and slides in together, with a hole on one side to pass the 3 wires through