RC Flying Wing Fuselage for small Printers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cut in Half Fuselage for Tom Stantons RC flying wing.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 83
- Wydruki
- 0
- Wyświetlenia
- 1093
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
Very similar to ST61 I had to cut the FuselageBack STL into two pieces as my Printer can not print such high things.
So normaly I would not upload this remix again, but there is a slightly diffence.
I cutted the part not right trough that strut, therefor I increased the contactarea and avoided to weaken that strut.
In my own print I used support (FuselageBack2) for angles over 80degree, but ST61's idea of cutting the part into three pieces is genius so I added a second set of STLs.
(FuselageBack2main & FuselageBack2motorholder)
As my slicer (Cura) had some issues with the thin walls of that CG-Circles, sothat it made holes from it, I added a STL of two 10mm cricular plates that fit into these holes.
How I Designed This
took Stanton's STLs and modified them with meshmixer.
Category: R/C Vehicles