RC Flying Wing Fuselage for small Printers
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cut in Half Fuselage for Tom Stantons RC flying wing.
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 83
- Makes
- 0
- Views
- 1,093
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Very similar to ST61 I had to cut the FuselageBack STL into two pieces as my Printer can not print such high things.
So normaly I would not upload this remix again, but there is a slightly diffence.
I cutted the part not right trough that strut, therefor I increased the contactarea and avoided to weaken that strut.
In my own print I used support (FuselageBack2) for angles over 80degree, but ST61's idea of cutting the part into three pieces is genius so I added a second set of STLs.
(FuselageBack2main & FuselageBack2motorholder)
As my slicer (Cura) had some issues with the thin walls of that CG-Circles, sothat it made holes from it, I added a STL of two 10mm cricular plates that fit into these holes.
How I Designed This
took Stanton's STLs and modified them with meshmixer.
Category: R/C Vehicles