Bambu Long Drop Poop Chute

Ok so I needed a slightly different version of the chute for my particular setup as I have 2 Bambu printers sitting next to each other. If you have one of these you know when it shoots out the back it does have a tendency to ricochet against the wall but a short version of the chute by itself let things drop mostly straight down. Mostly.

This newer version has a much longer ‘chute’ with double the magnets (8mm diameter x 3mm thick) to make sure the filament when it shoots out the back goes straight down. I kept one side open much like the original that saves on filament and print time, but means you need to use tree supports to print this straight up for the least hassles.

For my setup the next thing is adding a small adapter and curve to the bottom so I can have the filament drop straight into a cereal container (I found they are tall, narrow and big, so perfect for filament collection). I probably should have added some notches for attaching extensions but it's what I need for my setup personally, so I might add those in later (or you can make your own version.

UPDATE - I added in the extra scoop part I made for myself. As mentioned I wasn't clever I just went with glue, so I added an extra piece to give you something to glue/join. You shouldn't need supports for the extension or adapter but you do need one for the chute