Replicator 2 Cockpit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This replaces the OEM part for which I have yet to figure out the name of, so I've taken to calling it the cockpit.…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This replaces the OEM part for which I have yet to figure out the name of, so I've taken to calling it the cockpit. There are a few already out there. They hold the blower fan and filament tube for the Replicator 2 extruder. There were a few tweaks I was always left wanting. I finally got out the caliper, pen and paper and made one from scratch.
It resists melting fairly well. It also gets down with the cable management action via the cable tie routing. I wouldn't call it feed tube friendly. <11/9/13 Fixed clearance issue in model>
This pairs nicely with:
- CreativeTools filament dust filter: http://www.thingiverse.com/thing:52203
- whpthomas' Downward blower duct: http://www.thingiverse.com/thing:140254
4/30/14 Added Step model for those wishing to customize the design. 6/13/15 Added a file for models that shipped with the shorter 5mm mounting screws.
Instructions
3 shells 33%fill 1-200 micron. After you re-attach the blower fan give the 2 hex bolts 1 last little twist for good measure.
Category: 3D Printer Parts