1 / 13
Raspberry Pi 4B With Camera Slot, 40mm Fan, Well Vented Case — zdjęcie 1
1 / 13

Raspberry Pi 4B With Camera Slot, 40mm Fan, Well Vented Case

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a Remix to Michael Kellsy "mkellsy" original Raspberry Pi 4B case design which he did a great job. My…

Ocena
5 / 5
Polubienia
5
Pobrania
48
Wydruki
1
Wyświetlenia
391
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a Remix to Michael Kellsy "mkellsy" original Raspberry Pi 4B case design which he did a great job. My rendition modifies the top of the case to have slotted vents instead of the honeycomb design "the honeycomb can be a pain to print correctly". Using a 40mm case fan "will be needed to be mounted on the outside". I also added the camera slot for the ribbon cable that was missing on the original. I have also modified the bottom of the 8020 case. Again added the slotted vents instead of the honeycomb design.

The original can be found here: https://www.thingiverse.com/thing:3793664

04-19-2020 Update: I have added 75mm VESA vented base & modified the top of the case for max cooling with side vents with a port on top to see the status LED on the Pi board.

You can also use whichever fan grill you like. I have not included the fan grill, because I did not designed it. But if you would like to get it from the designer Prot0typ1cal, He did an amazing job you can get it here: https://www.thingiverse.com/thing:1750976

I'd recommend using either the Noctua NF-A4x10 5V Version Fan (40x40x10mm) or Noctua NF-A4x20 5V Version Fan (40x40x20). The only difference is the height 10 vs 20 mm and the 20mm RPM is a little faster. Both are very quiet & Noctua fans are built to last. As a reference the fan in the picture is the 40x40x20.

Note to content creators (YouTube, Patreon, Educators, etc). Yes I understate that you are "technically" getting paid in the backend for creating content & thank you for creating that content. So to expand everyone's knowledge, you have permission to use this design in your content as long as you: State that it is not yours & acknowledge who designed it. Provide a link to where you got it from, so others can download & enjoy it as well.

BTW if you like my design, please don't forget the click the "like" button & show you appreciation.

Thanks & Enjoy!

Print Settings

Printer Brand:

TEVO

Printer:

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

20% or better

Filament: Your Choice PLA Your Choice


Notes:

I printed it on blue painter's tape that I prepped with isopropyl alcohol to remove the wax film. Using 3D Solutech PLA black filament the initial bed temp was 60C, nozzle temp 205, no cooling fan, & print slow on the first layer (I had it at 25). On the 2nd layer to finish drop to bed temp 50C, nozzle temp 205, cooling fan high, & increase print speed back to normal.

Category: 3D Printer Accessories

Tagi