1 / 3
Lukki's Filamentführung Prusa no-jump filament guide with bearing remix — zdjęcie 1
1 / 3

Lukki's Filamentführung Prusa no-jump filament guide with bearing remix

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Adding bearing entry guides to Lukki's filament guide. mks3+ Never have your filament leave the spool again

Ocena
0 / 5
Polubienia
4
Pobrania
18
Wydruki
0
Wyświetlenia
273
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Lukki's filament guide is perfect at preventing filament from jumping the spool on tall prints.   

The original hole was a little sharp on the edges and I could see the filament pulling the end some as it moved at an angle through the hole.   I drilled the original a little larger to compensate.   When I started printing in flex and from dry boxes for certain filaments, the resistance had to go.

This remix adds a bearing position in front and behind the feed hole.  The feed hole is now huge as Lukki left lots of room in the frame design.

You can use a real 688 bearing or get pretty much the same result printing the slug bearing.  You can mix or match.  In the illustration I have a real bearing on the inside edge and a plastic printed slug bearing on the front edge.  A 688 Bearing is 5mm W x 16mm Dia x 8mm Center Diameter.

Lukki's fit to the mks3+ bar is perfect with just enough play you can slide it with some pressure side to side but I have never had it detach.

I kind of went for symmetry in printing the bracket so it may appear a little thick.  As little fill as you can get away with.

Assembly Notes:

  • Make sure the entry cuts are aligned when assembling the cap
  • Be sure to click the cap into the recessed holes
  • Refer to the illustration for assembly

Thanks Lukki for totally eliminating the problem of tall prints causing filament to jump the spool.

Tagi