Lukki's Filamentführung Prusa no-jump filament guide with bearing remix
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adding bearing entry guides to Lukki's filament guide. mks3+ Never have your filament leave the spool again
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 18
- Makes
- 0
- Views
- 274
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Lukki's filament guide is perfect at preventing filament from jumping the spool on tall prints.
The original hole was a little sharp on the edges and I could see the filament pulling the end some as it moved at an angle through the hole. I drilled the original a little larger to compensate. When I started printing in flex and from dry boxes for certain filaments, the resistance had to go.
This remix adds a bearing position in front and behind the feed hole. The feed hole is now huge as Lukki left lots of room in the frame design.
You can use a real 688 bearing or get pretty much the same result printing the slug bearing. You can mix or match. In the illustration I have a real bearing on the inside edge and a plastic printed slug bearing on the front edge. A 688 Bearing is 5mm W x 16mm Dia x 8mm Center Diameter.
Lukki's fit to the mks3+ bar is perfect with just enough play you can slide it with some pressure side to side but I have never had it detach.
I kind of went for symmetry in printing the bracket so it may appear a little thick. As little fill as you can get away with.
Assembly Notes:
- Make sure the entry cuts are aligned when assembling the cap
- Be sure to click the cap into the recessed holes
- Refer to the illustration for assembly
Thanks Lukki for totally eliminating the problem of tall prints causing filament to jump the spool.