spiggytech Volcano Nozzle to AnkerMake M5 gauge
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a tool for sizing up and measuring an E3D V6 Volcano nozzle for modification to AnkerMake M5
- Ocena
- 5 / 5
- Polubienia
- 31
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 2255
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
USE AT YOUR OWN RISK
Nozzles are in short supply at the moment so I developed this tool block as a means of floating by until someone produces dedicated M5 nozzles. I have the hardenedsteel ones, but I don't like working with them. This is an answer to my problem. It might help you too.
This project is a tool block for sizing up and measuring E3D V6 Volcano nozzles for modification to AnkerMake M5 hot ends. The tool will help you determine the length of cut and sizedown for the appropriate fitment.
I've used this on brass and brass/ruby nozzles. I don't recommend two-part nozzles as some ruby/PCD nozzles require peening the end or the ruby will come loose. And I don't recommend hardened steel as it is difficult to cut and polish.
Note: this is for marking the nozzle. If you intend on using the block to cut, a bucket of cold water for dipping is necessary to ensure the block stays cool and in shape.
There are three parts.
- Volcano Gauge
- A press to hold the nozzle
- And a stop (squared donut) that confirms the nozzle is seated in a square
Instructions:
- Put the Volcano Nozzle in the block
- Press it with the Press
- Fit the stop to ensure the nozzle is square
- Use a sharpie to mark the excess trim area
- Done! The nozzle is now marked!