1 / 6
Print-in-place Business Card Holder/Stand — zdjęcie 1
1 / 6

Print-in-place Business Card Holder/Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A business card holder with a print-in-place folding mechanism that converts the case into a freestanding display stand.

Ocena
5 / 5
Polubienia
158
Pobrania
581
Wydruki
10
Wyświetlenia
3290
Oceny
7

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution

This gadget securely holds your business cards without hiding the graphics you've worked hard to develop! The print-in-place mechanism locks the holder in the closed position. The holder is opened by pulling the two halves apart and swinging the upper half backwards to act as a stand, proudly displaying your card during events or as a permanent desk feature!

Printing guide

 I've had good results printing with the following settings:

  • Material: PLA
  • Layer height: 0.2mm
  • Profile: PrusSlicer "0.2mm Quality"
  • Shells: Three
  • Supports/bed adhesion: Not required

 

Assembly

The model  simply prints as is and requires no assembly. The mechanism can take a little wiggling to loosen up initially depending on your machine and your first layer calibration.

 

 Usage

To open the holder, gently pull the two halves apart as shown by grabbing them at the finger grooves:

Then, swing the upper half backwards until it clicks into the open position:

To close, simply reverse the steps above.

Happy printing!

Tagi