1 / 6
Print-in-place Business Card Holder/Stand — image 1
1 / 6

Print-in-place Business Card Holder/Stand

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A business card holder with a print-in-place folding mechanism that converts the case into a freestanding display stand.

Rating
5 / 5
Likes
158
Downloads
581
Makes
10
Views
3,290
Reviews
7

Updated at source:

Model information

Category
Office
License
Creative Commons — Attribution

This gadget securely holds your business cards without hiding the graphics you've worked hard to develop! The print-in-place mechanism locks the holder in the closed position. The holder is opened by pulling the two halves apart and swinging the upper half backwards to act as a stand, proudly displaying your card during events or as a permanent desk feature!

Printing guide

 I've had good results printing with the following settings:

  • Material: PLA
  • Layer height: 0.2mm
  • Profile: PrusSlicer "0.2mm Quality"
  • Shells: Three
  • Supports/bed adhesion: Not required

 

Assembly

The model  simply prints as is and requires no assembly. The mechanism can take a little wiggling to loosen up initially depending on your machine and your first layer calibration.

 

 Usage

To open the holder, gently pull the two halves apart as shown by grabbing them at the finger grooves:

Then, swing the upper half backwards until it clicks into the open position:

To close, simply reverse the steps above.

Happy printing!

Tags